Ara
Toplam kayıt 79, listelenen: 21-30
Determination of Optimum Operation Cases in Electric Arc Welding Machine Using Neural Network
(2011)
With arc welding machines, welding is only performed at optimum operating points. Determination of optimum operating points is important so as for welding machines which will be produced in future to be developed in a ...
Spectral Analysis for Current and Temperature Measurements in Power Cables
(2009)
This research aims to detect spectral properties under thermal and current variations for power cables. Therefore, spectral diversities are exposed under current unbalances and different load conditions through the ...
Mechanical Properties of Fly Ash and Blast Furnace Slag Based Alkali Activated Concrete
(2017-12)
Cement is one of the commonly used materials in construction projects. In manufacture of Portland cement, clinker, which is the essential component of cement, is ground into smaller particles. During the formation of ...
Vortex Lattice of a Bose–Einstein Condensate as a Photonic Band Gap Material
(2008)
Photonic crystal behavior of a rotating Bose–Einstein condensate with a triangular vortex lattice is reviewed and a scheme for getting much wider band gaps is proposed. It is shown that photonic band gaps can be widened ...
A Neuro Detector Based on the Cybernetic Concepts for Fault Detection in Electric Motors
(2011)
In this study, an auto-associative neural network (AANN) is designed as a fault detector using the cybernetic concepts. In this sense, an artificial neural network structure is connected with a finite state system or a ...
Reverse Power Data Analysis and Feature Extraction Based Upon Continuous Wavelet Transform for Electric Power Plants
(2010)
This study is focused on the investigating of a power plant generator in reverse power condition. For this purpose, reverse power data were collected from a Combined Heat and Power Plant generator protection relay. The ...
Development of 10kW three-phase grid connected inverter
(KoREMA, 2016)
In this paper, modeling, simulation and experimental study of a 10kW three-phase grid connected inverter are presented. The mathematical model of the system is derived, and characteristic curves of the system are obtained ...
AN EXPERIMENTAL STUDY ON WALL THICKNESS DISTRIBUTION IN THERMOFORMING
(Lublin Univ Technology, Poland, 2017)
In this work, Polystyrene (PS) sheets were thermoformed in predetermined conditions. Wall thickness distributions obtained by experimental method in PS thermoformed products. Then the same thickness distributions were ...
A new process damping model for chatter vibration
(2011)
This paper presents a new analytical process damping model (PDM) and calculation of Process Damping Ratios (PDR) for chatter vibration for low cutting speeds in turning operations. In this study a two degree of freedom ...
Wear characteristics of PLA-Cu composites manufactured by fused deposition modelling under different temperature conditions
(2021)
Copper shows promising characteristics for applications in electrical sliding contacts. In this study, copper reinforced polylactic acid (PLA-copper) composites manufactured by fused deposition modeling (FDM). Wear behaviour ...