Ara
Toplam kayıt 34, listelenen: 11-20
Effects of infill pattern and density on wear performance of FDM-printed acrylonitrile- butadiene-styrene parts
(Walter De Gruyter Gmbh, 2021)
Acrylonitrile-butadiene-styrene test specimens were additively manufactured by fused deposition method to investigate the effects of infill pattern and density on wear rate, coefficient of friction, wear mechanisms, and ...
AN EXPERIMENTAL STUDY ON WALL THICKNESS DISTRIBUTION IN THERMOFORMING
(Lublin Univ Technology, Poland, 2017)
In this work, Polystyrene (PS) sheets were thermoformed in predetermined conditions. Wall thickness distributions obtained by experimental method in PS thermoformed products. Then the same thickness distributions were ...
A new process damping model for chatter vibration
(2011)
This paper presents a new analytical process damping model (PDM) and calculation of Process Damping Ratios (PDR) for chatter vibration for low cutting speeds in turning operations. In this study a two degree of freedom ...
Wear characteristics of PLA-Cu composites manufactured by fused deposition modelling under different temperature conditions
(2021)
Copper shows promising characteristics for applications in electrical sliding contacts. In this study, copper reinforced polylactic acid (PLA-copper) composites manufactured by fused deposition modeling (FDM). Wear behaviour ...
Effect of temperature on wear behavior of multilayered thin cr-coated acrylonitrile-butadiene-styrene polymer: An experimental and prediction study
(ASTM International, 2022)
The wear behavior of thin chromium-coated and uncoated acrylonitrile-butadiene-styrene (ABS) samples were investigated by using a pin-on-disk test apparatus with a heat chamber for different temperatures of 30°C, 50°C, ...
The Effect of Temperature on Wear Performance of High-Velocity Oxy-Fuel Sprayed WC-10Co-4Cr Coating on AA7075-T6 Substrate
(Springer, 2021)
In this study, the friction wear performance of a High-velocity oxy-fuel (HVOF) sprayed WC-10Co-4Cr coated AA7075-T6 substrate was investigated against a WC-4Co ball at different temperatures using a pin-on-disk tribometer. ...
Drying of Prina Using Microwave Energy and Determination of Appropriate Thin Layer Drying Model
(Univ Namik Kemal, 2015)
This study examined the thin layer drying kinetics of the prina in the microwave. Prina samples with 7mm, 9mm and 11mm thickness were dried using 90, 180, 360 and 600 W (2450 MHz) microwave output powers and changing of ...
Modelling of dynamic cutting force coefficients and chatter stability dependent on shear angle oscillation
(Springer London Ltd, 2017)
Productivity of high-speed turning operations is limited by the onset of self-excited vibrations known as chatter. Unless avoided, chatter vibrations may cause large dynamic loads damaging the machine spindle, cutting tool ...
CFD modelling and experimental validation of cell performance in a 3-D planar SOFC
(Pergamon-Elsevier Science Ltd, 2019)
Fuel cells can be used to provide power for most electrical or electronic devices designed for operation from batteries or from conventional utility power sources. In this study, a three dimensional Computational Fluid ...
Kalıp Tasarımının Isıl Şekillendirilmiş Ambalajın Kalınlık Dağılımı Üzerine Etkisi
(2020)
Isıl şekillendirme prosesi gerek otomotiv gerekse ambalaj sanayiinde en çok kullanılan proseslerden biridir. Bu çalışmada,Polivinil klorür (PVC) filmlerin, erkek kalıpla ısıl şekillendirme sonrası kalınlık dağılımları ...