Ara
Toplam kayıt 9, listelenen: 1-9
Process damping model approach in milling operations
(Springer Heidelberg, 2021)
The subject of this study is a new Process Damping Model approach for milling with flat end milling cutter. Dynamic model of the cutting system was modeled and applied for the milling operation. The machining process is ...
Design of a broadband elastic metamaterial via topologically optimized inertial amplification mechanisms
(European Association for Structural Dynamics, 2020)
Elastic metamaterials enable to generate phononic band gaps below the Bragg limit. Most metamaterials in the literature are based on vibration absorption (local resonance) principle. In this study, a two dimensional elastic ...
The Effect of Temperature on Wear Performance of High-Velocity Oxy-Fuel Sprayed WC-10Co-4Cr Coating on AA7075-T6 Substrate
(Springer, 2021)
In this study, the friction wear performance of a High-velocity oxy-fuel (HVOF) sprayed WC-10Co-4Cr coated AA7075-T6 substrate was investigated against a WC-4Co ball at different temperatures using a pin-on-disk tribometer. ...
Modelling of dynamic cutting force coefficients and chatter stability dependent on shear angle oscillation
(Springer London Ltd, 2017)
Productivity of high-speed turning operations is limited by the onset of self-excited vibrations known as chatter. Unless avoided, chatter vibrations may cause large dynamic loads damaging the machine spindle, cutting tool ...
CFD modelling and experimental validation of cell performance in a 3-D planar SOFC
(Pergamon-Elsevier Science Ltd, 2019)
Fuel cells can be used to provide power for most electrical or electronic devices designed for operation from batteries or from conventional utility power sources. In this study, a three dimensional Computational Fluid ...
Analysis of wind energy potential; A case study of Kocaeli University campus
(Elsevier Sci Ltd, 2019)
Determination of the wind energy potential is achieved by point measurement at the place. MERRA software which is generated by NASA provides the point data values. The point data with using Windographer software gives ...
Development of a new model for determine of cutting parameters in metal drilling processes
(Springer Heidelberg, 2020)
Metal drilling and cutting processes are used commonly in many areas of the industry. When these processes investigated analytically, it is seen that they have a very complicated structure. This complicated structure can ...
Drying behavior of prina (crude olive cake) using different types of dryers
(Taylor & Francis Inc, 2016)
The purpose of this research is to investigate the drying kinetics and determine the suitable drying method of prina, which is obtained after pressing of olives in olive oil factories, and which cannot be used efficiently ...
Thermoforming of biopolymer-green polyethylene sheets
(ModTech Publishing House, 2018)
Thermoforming is a forming technique in which petrochemical-based thermoplastics, biodegradable plastics and also plastic composites can be formed. Due to recent developments in the packaging industry, it was understood ...