Ara
Toplam kayıt 8, listelenen: 1-8
Linear analysis of chatter vibration and stability for orthogonal cutting in turning
(2011)
The productivity of high speed milling operations is limited by the onset of self-excited vibrations known as chatter. Unless avoided, chatter vibrations may cause large dynamic loads damaging the machine spindle, cutting ...
Decomposition of Process Damping Ratios and Verification of Process Damping Model for Chatter Vibration
(2012)
In the previous study, by the same authors, titled ‘‘A new process damping model (PDM) for chatter vibration (Measurement, 44 (8) (2011) 1342–1348)’’, a new approach has been presented for obtaining process damping ratios ...
A simple approach to analyze process damping in chatter vibration
(2014)
This paper investigates how changes in chatter amplitude and frequency depend on process damping effect in dynamic turning process. For this purpose, the two degrees of freedom (TDOF) cutting system was modeled, and for ...
Optimization of tool geometry parameters for turning operations based on the response surface methodology
(2011)
This investigation focuses on the influence of tool geometry on the surface finish obtained in turning of AISI 1040 steel. In order to find out the effect of tool geometry parameters on the surface roughness during ...
Process damping model approach in milling operations
(Springer Heidelberg, 2021)
The subject of this study is a new Process Damping Model approach for milling with flat end milling cutter. Dynamic model of the cutting system was modeled and applied for the milling operation. The machining process is ...
A new process damping model for chatter vibration
(2011)
This paper presents a new analytical process damping model (PDM) and calculation of Process Damping Ratios (PDR) for chatter vibration for low cutting speeds in turning operations. In this study a two degree of freedom ...
Modelling of dynamic cutting force coefficients and chatter stability dependent on shear angle oscillation
(Springer London Ltd, 2017)
Productivity of high-speed turning operations is limited by the onset of self-excited vibrations known as chatter. Unless avoided, chatter vibrations may cause large dynamic loads damaging the machine spindle, cutting tool ...
Development of a new model for determine of cutting parameters in metal drilling processes
(Springer Heidelberg, 2020)
Metal drilling and cutting processes are used commonly in many areas of the industry. When these processes investigated analytically, it is seen that they have a very complicated structure. This complicated structure can ...