Yazar "Ekşi, Olcay" için WoS İndeksli Yayınlar Koleksiyonu listeleme
-
Application of parabolic blending for the estimation of thickness distribution in thermoformed products
Ekşi, Olcay; Üstünel, Hakan (Sage Publications Ltd, 2021)The Parabolic Blending (PB) technique has been widely used in various research fields, such as rotor noise prediction, over the last few decades. However, in the literature, PB is not utilised for the thickness prediction ... -
THE EFFECT OF PROCESS PARAMETERS ON THICKNESS DISTRIBUTION IN THERMOFORMING
Ekşi, Olcay; Karabeyoğlu, Sencer Süreyya (Lublin Univ Technology, Poland, 2017)In this study, cylindrical, conical and hemispherical molds were used to form flat thermoplastic sheets which are 1.5 mm in thickness. The effect of plug assist on thickness distribution was investigated. The sheets were ... -
Effects of infill pattern and density on wear performance of FDM-printed acrylonitrile- butadiene-styrene parts
Karabeyoğlu, Sencer Süreyya; Ekşi, Olcay; Yaman, Paşa; Küçükyıldırım, Bedri Onur (Walter De Gruyter Gmbh, 2021)Acrylonitrile-butadiene-styrene test specimens were additively manufactured by fused deposition method to investigate the effects of infill pattern and density on wear rate, coefficient of friction, wear mechanisms, and ... -
Experimental and numerical study on the thermoforming process of amorphous thermoplastic polymers
Ekşi, Olcay; Karabeyoğlu, Sencer Süreyya; Çınar, Kenan (Carl Hanser Verlag, 2019)Thickness distribution has an important impact on the quality of thermoformed products. It has significant effects not only on durability but also on the oxygen and gas transmission rate of thermoformed packaging products. ... -
AN EXPERIMENTAL STUDY ON WALL THICKNESS DISTRIBUTION IN THERMOFORMING
Karabeyoğlu, Sencer Süreyya; Ekşi, Olcay; Erdoğan, Selçuk (Lublin Univ Technology, Poland, 2017)In this work, Polystyrene (PS) sheets were thermoformed in predetermined conditions. Wall thickness distributions obtained by experimental method in PS thermoformed products. Then the same thickness distributions were ... -
Thermoforming behavior of 3D-printed PLA sheets
Ekşi, Olcay; Karabeyoğlu, Sencer Süreyya; Çınar, Kenan; Mühürcü, Aydın (Carl Hanser Verlag, 2020)Fused deposition modeling is one of the most well-known additive manufacturing methods. It might be considered the easiest way to produce particle reinforced composites or unreinforced sheets which are biodegradable and ...